Satellite Antennas and Accessories

AND-30_38PF
Viking Satcom AND-300AZ/PLR & AND-380AZ/PLR
The Viking Satcom AND-300AZ/PLR & AND-380AZ/PLR are prime focus 3.0 & 3.8 Meter Sectional Antennas.
icon_acrobat

P450
Viking Satcom P450FAE
The Viking Satcom P450FAE is a prime focus 4.5 Meter Sectional Antenna.
icon_acrobat

Viking Satcom VS-SSE45FAE & VS-SSE45MAE
Viking Satcom VS-SSE45FAE & VS-SSE45MAEThe Viking Satcom VS-SSE45FAE & VS-SSE45MAE are 4.5 Meter Prime Focus Receiver Only Antennas- 12 Panel Reflector

Quintech LS 2150A
Quintech LS 2150AThe Quintech LS 2150A Series commercial quality active (zero loss) L-band splitters meet strict level, match, and loss specifications achieved through the use of Quintech’s proprietary microstrip and SMT technology.

Quintech LS 2150P
Quintech LS 2150PThe Quintech LS 2150P Series are passive satellite L-band splitters which permit simple splitting of RF signals. These commercial quality splitters meet strict level, match and loss specifications achieved through the use of Quintech’s proprietary microstrip and SMT technology.

Quintech RFS-2150
Quintech RFS-2150The Quintech RFS 2150 L-band Redundancy Switch detects the presence of primary RF signal feed and provide the ability to switch to a backup (secondary) signal upon the loss of the primary.

Quintech RPS2460QAB000
Quintech RPS2460QAB000The Quintech RPS2460QAB000 Series Redundant Power Supply provides a centralized power source for as many as 16 LNAs, LNBs, upconverters, downconverters, and line amplifiers. The unit is comprised of two separately fused power supply modules configured for nominal voltage or +24 VDC @ 6.0 amps and has been designed for international use with an input voltage of 100-240 VAC, 50/60 Hz. The power supply modules are on individual drawers to provide easy replacement of a failed module. Both supplies are monitored by a summary alarm which employs a serial RS-422 interface. On the rear panel, green LEDs indicate power status for each of the input ports. Each input port is capable of supplying up to 900 mA through an automatically resetting circuit breaker. Loads in excess of 900 mA will ‘trip’ the breaker, shutting down the input port until the current demand drops below the trip point.

Microwave Filter 13961
Microwave Filter 13961The Microwave Filter 13961W combines innovative design techniques with the solid performance of its renowned predecessor (model 13961).

Microwave Filter 7893D
Microwave Filter 7893DThe Microwave Filter Series 7893D C-Band bandpass filter is installed between a TVRO feedhorn and the LNA or LNB to suppress strong out-of band interference caused by marine or airport radar systems. Coastal and marine navigational radar frequencies (2.9-3.65 GHz) are just below the TVRO band and frequently wipe-out transponders 1-5 in TVRO’s installed near harbors. The airport altimeter band (4.25-4.40 GHz) will affect channels 22-24 at TVRO sites near airports. The Microwave Filter model 7893D interference filter operates at RF before down conversion. This prevents the generation of undesirable mixer products and receiver “desensitization” due to strong out of band signals.

Norsat LNB 1000H
Norsat LNB 1000HThe Norsat 1000H Series LNB offers better PLL Stability and Phase Noise in a compact package. The Norsat 1000H Series LNB is designed to provide commercial quality for VSAT and select digital applications such as: -Low data rate digital video -A reference LNB for Receiver test & service -SCPC digital or analog audio -Low speed SCPC data from 19.2 kbps – 512 kbps, or any higher data rate.

Norsat LNB 3000
Norsat LNB 3000The Norsat LNB 3000 Data is Norsat’s premium quality C-band PLL LNB. The preferred LNB for all C-band applications. The Norsat 3000 series is designed to provide higher performance for VSAT and select digital applications such as: – Low data rate digital video – A reference LNB for Rx test and service – SCPC digital or analog audio applications – Low speed SCPC data from 19.2 Kbps to 512 Kbps, or any higher data rate.

Norsat LNB 4000
Norsat LNB 4000The Norsat LNB 4000 Series offers built-in transmitter filter, best DRO stability and Phase Noise in a compact package. The Norsat 4000 series is designed to provide higher performance for VSAT and select digital applications such as: *Higher data rate digital video or commercial analog *Some SCPC digital or analog audio applications *Any SCPC data rate above 1 Mbps.

Norsat LNB 8000
Norsat LNB 8000The Norsat LNB 8000 Series is designed to provide commercial quality for VSAT and select digital applications.

DX Antenna SED-772, SED-774, SED-776, SED-778, SED-1071
DX Antenna SED-772, SED-774, SED-776, SED-778, SED-1071DX Antenna Splitters
SED-772, SED-774, SED-776, SED-778, SED-1071

Tekron RSS-2L
Tekron RSS-2LThe Tekron RSS-2L is designed to monitor both the Vertical & Horizontal polarized LNB feeds (950-1450 MHz) independently and from the same chassis, with automatic switchover to backup LNB feeds.The threshold level at which the unit switches to the backup feed is adjustable and separate for the Vertical and the Horizontal primary feeds.

MCL MT2300
MCL MT2300The MCL MT2300 (Not for Sale in the USA or Canada) is an antenna mount traveling wave tube low power amplifier and is the rugged and economical solution for uplink applications. Features include – Compact Weather-Resistant Package – Extensive Diagnostic Capability – Designed to Meet MIL-188-164A – Software Communications Configuration for Both Remote and Computer Interfaces – Continuous Attenuator Adjustment shown in dB – Auto Power Control and Status – Rugged Construction for Extreme Environments – MTBF: 81,000 Hours (Tube) 193,686 Hours (Power Supply).

MCL MT3200A
MCL MT3200AThe MCL MT3200A (Not for Sale in the USA or Canada) is a traveling wave tube medium power amplifier for satellite uplink applications which features Reduced Depth – Output RF Power Hold- Easily Accessible Diagnostic Port – Programmable Alarms – Event And Maintenance Logs – Ethernet Interface – Field Replaceable Modules For Unsurpassed Serviceability Closed-Loop Forced Air Cooling – Typical Phase Noise 12 dB Below IESS-308 – Control Dial For Easy Set-Up And Adjustment.

MCL MT4000
MCL MT4000The MCL MT4000 (Not for Sale in the USA or Canada) traveling wave tube medium power amplifier for satellite uplink applications which features Event Log Screen with Report of Failure – Level, Date, and Time – Auto Power Control and Status – Continuous Attenuator Adjustment in dB – Filament Off State – Local, Remote, or Computer Control Modes – Optional Linearizer Control – Front Panel RS232 Diagnostic Interface.

MCL Redundant Systems
MCL Redundant SystemsMCL Redundant Systems- (Not for Sale in the USA or Canada), Each amplifier in the MCL product line is available in a number of redundant configurations to accommodate system redundancy or to combine outputs of multiple amplifiers to increase system output power. Standard configurations include 1:1 Redundant Systems, 1:2 Redundant Systems, Phase Combined Systems, 1:2 Redundant Phase Combined Systems, and Variable Phase Combined Dual Feed Systems. Other configurations are available upon request.

NOTE: You may need the FREE Adobe Reader
to view this document. If you do not have it installed
on your computer, you can download it here:

 

This entry was posted in . Bookmark the permalink.